Introduction:

JIC Fitting is a selection of hydraulic fittings which is made in accordance to the SAE J514 requirements. The acronym JIC stands for Joint Industry Council. It's likewise known as the JIC 37 degrees flare fitting as it's a thirty seven degrees flare seating surface. These fittings are used on oil hydraulic methods in many fields (fuel delivery, etc...), mobile hydraulic equipment, shipbuilding, fuel power application. A JIC fitting system has 3 segments which create a tubing assembly: fitting, flare nut, and sleeve.

Material:

Materials used-to fabricate JIC fittings are stainless-steel and carbon steel SS316L.

Sizes:

JIC body and flare nut are obtainable in exterior diameter ("OD) sizes between 1/8" to 1 2". Sleeve has two distinct reading measurements, metric size (mm) and inch outer diameter ("OD). Sleeve size can be purchased from 3mm to 50mm and 1/8" to 2". Fitting sizes are designated by the corresponding outside diameter of the tubing for the various types of tube ends.

Working Pressure:

The conventional working pressure of the fittings ranges from thousand to 5000 psi for various sizes and connections. The minimum burst pressure is four times the working pressure. The JIC fittings should be in a position to withstand two times the working strain for a period of 1 minute without leakage or failure.

Please take note that the pressure rating of an exact same fitting may vary when it's connected to different equipments.. For example, if a fitting with a reduced performing pressure is attached to a pipe, it is going to result in an overall even reduce working strain. In all cases, constantly take into account the lowest pressure as the maximum working pressure of the system.

Just how does a JIC fitting works: For tube connections, the assembly treatment starts out of the planning of the hose. For starters, the nut as well as sleeve are inserted onto the conclusion of a hose. With all the use of a flaring tool, create the conclusion of the tube to 37 degrees. Then, tighten the nut by making use of a spanner until the nut is tight and also the sleeve grips onto the tube. If the fittings are bench put together, the gripping action might be driven by revolving the tubing manually as the nut is drawn down. When the tube could not anymore be driven by hand, the sleeve has gripped upon the tube. If this occurs,, phenq Side effects (Socialnewsdaily.com) tighten the nut by switching it one complete turn. This may vary more or less with different tubing substances, but for common practice, it is a very good rule to adhere to.

Configurations of JIC Fitting: Commonly made use of connection sorts comprise of: JIC/BSPP Male Connector, JIC/ NPT Male connector, JIC union, JIC/NPT Swivel Male Connector, JIC/BSPP Swivel Male Connector.

Brand of JIC Fittings:

HS Corporation is a Korean company specializing in JIC Fitting. Established in 1980, HS Corporation has over 30 years of specialised knowledge in manufacturing fittings.